verifiedbackuppowerdata
Water

How many watts does a well pump use, and how long will a battery run it?

Well pumps draw about 700–2,000 W while running and up to 6,000 W for a moment as the motor starts. It cycles on and off, so a typical one uses about 1,600 watt-hours a day, about 65 W on average over the day, because it runs only a few minutes at a time. None of the 12 1 kWh stations we track can run it: it needs 240 volts.

None of the 14 2 kWh stations we track can run it: it needs 240 volts.

That is the middle of our range for this appliance. Yours may use less or a lot more: the range, the assumptions and every unit we track are below. Hours are hours of use on one full charge, counting about 85% of the battery as usable.

Hours of use by battery size (240 V stations only)

Battery (nameplate)TypicalHard-working unitEfficient unit
3,000 Whabout 39 h8.5 h182 h
5,000 Whabout 66 h14 h304 h

Hours = 85% of the nameplate battery divided by average watts. Typical uses about 65 W; hard-working 2,000 W on 15% of the time; efficient 700 W on 2% of the time. The station must also start it: see which units can, below.

How much battery a typical one needs

OutageBattery needed, typical
12 hoursabout 910 Wh
24 hoursabout 1,800 Wh
3 daysabout 5,500 Wh

Nameplate watt-hours, so the 85% usable share is already counted. Past a day, most plans add solar or a generator rather than a bigger battery.

The range behind that

A well pump uses about 700–2,000 watts while running , and needs up to 6,000 watts for a split second when it starts. Over 24 hours it uses roughly 336–7,200 watt-hours.

Buy for the higher number in each range. 12 of the 73 products we track can run it. For example, the Zendure SuperBase V6400 would run it for 18–391 hours of use, from a hard-working unit to an efficient one.

This one is not plug-and-play. It is wired into your house, so you need a licensed electrician.

Sized in a full plan

This load is part of a plan we ran against every unit we track, with picks: The best backup power for a well pump.

The numbers behind that

A well pump only runs while refilling the pressure tank, so total energy is modest, but the starting surge is the largest in a typical home.

Running wattswatts
Best case700 Plan for this2,000

What it draws while it is actually on.

Starting wattswatts
Best case2,000 Plan for this6,000

The momentary surge when a motor or compressor kicks in. Undersized systems fail here, not on running watts.

Startup surge compared with running wattsA chart of power over time. The line sits at zero while the fridge is off, jumps briefly to about 2,900 watts when the compressor starts, then settles at about 700 watts while it runs. watts time → 700W running 2,900W startup spike under a second off
A refrigerator draws about 700W while running, but jumps to roughly 2,900W for under a second when the compressor kicks in. That spike is what shuts down an undersized power station — not the running watts.
Duty cyclepercent of the time
Best case2 Plan for this15

How much of the hour it is actually drawing power. This is what turns running watts into energy.

Energy over 24 hourswatt-hours
Best case336 Plan for this7,200

Multiply the battery capacity you are considering by roughly 0.85 to compare like with like.

Wired into the building

This is connected to your house wiring, not an outlet. Powering it from a portable source needs a transfer switch or an inlet installed by a licensed electrician. Never run a cord from a generator into an outlet to feed a circuit: backfeeding can kill line workers and start fires.

Plugged-in appliances compared with wired-in appliancesTwo panels. On the left a fridge connects to a power station through a normal plug, which you can do yourself. On the right a furnace blower connects directly to the breaker panel with no plug, which requires a licensed electrician. Plugged in You can do this yourself fridge power station a normal plug Wired in Licensed electrician only furnace blower breaker panel no plug anywhere
If it has a plug, you can run it from a power station or a generator's outlet today. If it is wired into your house, no portable box can reach it without transfer equipment fitted by a licensed electrician.

Safety

Well pumps are hardwired and frequently 240V. This is professional-installation territory, and a 120V-only power station is not a candidate regardless of its watt-hour rating.

Check this yourself

Read the pump nameplate for horsepower and voltage. Many residential well pumps are 240V, which most portable power stations cannot supply at all.

What can run it

Hours of use on one full charge: typical, then the range from a hard-working unit to an efficient one. “Starts it” means the peak output covers even a hard-starting one; “may not start a hard-starting one” means it covers the lower end of the starting range only.

ProductContinuousPeakStarts it?Hours of use
Zendure SuperBase V64003,800W5,000Wmay not start a hard-starting oneabout 84h
18–391h
Jackery Explorer 5000 Plus7,200W14,400Wstarts itabout 66h
14–306h
Zendure SuperBase V46003,800W5,000Wmay not start a hard-starting oneabout 60h
13–280h
EcoFlow DELTA Pro 34,000W8,000Wstarts itabout 54h
12–249h
Anker SOLIX F38006,000W9,000Wstarts itabout 50h
11–233h
Champion 201513 6500W Inverter5,000W6,500Wstarts itfuel-dependent
Champion 201598 8500W Wireless Start Tri Fuel Inverter6,500W8,500Wstarts itfuel-dependent
Champion 201176 9000W Tri-Fuel Open Frame Inverter7,250W9,000Wstarts itfuel-dependent

Plan this with your other loads →

What will not work, and why

59 of 73 products cannot run this.

  • OUKITEL P5000 Pro — Your plan needs 240V output. This unit supplies 120V.
  • Goal Zero Yeti PRO 4000 — Your plan needs 240V output. This unit supplies 120V.
  • EcoFlow DELTA Pro — Your plan needs 240V output. This unit supplies 120V.
  • Jackery HomePower 3600 Plus — Your plan needs 240V output. This unit supplies 120V.
  • Anker SOLIX F3000 (UL9540 Certificated) — Your plan needs 240V output. This unit supplies 120V.
  • EcoFlow DELTA 3 Ultra (3072Wh) — Your plan needs 240V output. This unit supplies 120V.